Remove all loose concrete chips, spalls, islands, etc. As material may run back into cartridge and some material many not cure properly. DO NOT POINT GUN STRAIGHT BACK UP UNTIL DISPENSING IS COMPLETE. Note: Gun should remain pointed down throughout dispensing of cartridge. until color appears consistent in nature. Squeeze the first 3-4 short of material into a disposible cup, etc. After material reaches top of static mixer, tilt gun down and.Holdiing gun upward at a 90 degree angle, slowly pull trigger to.Using a standard / univeral caulking gun, pull back gun piston and.Place static mixer ontoĬartridge neck and secure rightly with lock nut. Several minutes for liquid to settle and for cartridge to “de-air”. Shake well before use (at least 45 seconds).must be used to warm up floor area prior to installing material. If concrete temperature is lower than 32F, temporary heat tenting, etc. Poly-Strong PS 55 is designed for use in concrete floors at temperatures of 32F or higher. Material should be preconditioned to 70-80F prior to use for best results. Allow concrete to fully cure at least 28 days prior to installation.
#Unmatched air traffic control crack free
Repair area should be completely free of dust, debris, dirt, oils and moisture prior to application of material.
#Unmatched air traffic control crack download
Non-Hazardous - Can be shipped overnight by air carrier to arrive on job site, next day.įor complete application instructions please download the Technical Data Sheet (TDS).Can be applied indoors without the use of masks or ventilator. Odorless - Unlike most crack repair products, this product contains virtually no oder, zero VOC’s, and no harmful vapors.Low-viscosity allows for penetration into cracks as narrow as 1/64” (.016” or.Can be ground flush with floor in 25 minutes.
PS-55 contains no VOC’s and is fully compliant with USGBC LEED v4.1 green building standards.
0 kommentar(er)
